1 - Wi-Fi connection

1 - Wi-Fi connection

1 - Install mobile app

Android
iOS





2 - Connect mobile device to the network the IIoT device needs to connect to (warning: 2.4 GHz only)

3 - Enter the password (PSK) for the targeted network in the app and leave the other settings as defaults (Device count : 1   Broadcast)

Android
iOS




4 - Ensure the IIoT device is ready to receive configuration: blue breathing LED

5 - Press CONFIRM

6 - The IIoT device connects to Wi-Fi and establishes first contact with ALIX: blue-green flashing LED

7 - The IIoT device automatically downloads its latest firmware: solid blue LED

8 - The IIoT device restarts automatically and connects to ALIX: solid green LED when device is ready

Note : If the Wi-Fi parameters are modified or if the device needs to be connected to another network, the procedure in this article needs to be repeated. To reset the IIoT device into Wi-Fi configuration mode, open the casing and hold down the blue tactile button labeled Wi-Fi setup for 4 seconds. The Status LED will tell when the device is ready to receive new configuration. Only Wi-Fi parameters are reset with this method, any configuration set in ALIX will remain unchanged.

    • Related Articles

    • Create a connection between Zoho Books and ALIX

      Summary It's is essential to create a two-ways connection between Zoho Books and ALIX. Without this connection, ALIX can synchronize information with Zoho Books, but the other way doesn't work. BEFORE creating the custom function, you need to create ...
    • Status LED

      The multicolored LED on the IIoT device represents its current state of operation. The following table presents the possible states. Color State Orange, solid Disconnected. Possible causes:  Device is starting (only takes a few seconds) Wi-Fi ...
    • Specifications

      Box contents Smart sensor Current tranformer (CT) clamp AC/DC adapter (power supply) Note : CT clamp and power supply appearance may vary from what is shown on picture. Please use included accessories only. Specifications Wi-Fi 802.11n connectivity ...
    • 3 - Configuration and monitoring in ALIX

      Equipement / IIoT device association Once connected to Wi-Fi, the IIoT device must be associated with an existing equipment in ALIX. Within the selected equipment's interface, in the IIoT configuration section (Figure 1 : 1), select the device from ...
    • 2 - Installation on equipment

      Disclaimers The current transformer (CT) clamp must be plugged into the smart sensor before clamping to a live conductor. A clamp over a live conductor with its jack connector unplugged entails a risk of electrical shock and could damage the clamp. ...